Summary for: OPsimulator < handle

Class summary

OPsimulator Class for analysing operating points.

Properties

.OPsimulator/N_DETAILED is a property.

.OPsimulator/N_PRE is a property.

.OPsimulator/UDC is a property.

.copts - set in this.reset()

.OPsimulator/current_waveform is a property.

.eqopts - set in this.reset()

.OPsimulator/fs is a property.

.modulator - FIXME refactor into single input

.OPsimulator/periods_detailed is a property.

.OPsimulator/periods_pre is a property.

.OPsimulator/simulation_type is a property.

.OPsimulator/supply_mode is a property.

.OPsimulator/verbose is a property.

Methods

Class methods are listed below. Inherited methods are not included.

.OPsimulator Class for analysing operating points.

Documentation for OPsimulator/OPsimulator doc OPsimulator

.OPsimulator/dispf is a function.

dispf(this, msg)

.get_max_torque_eq Maximum torque at given rpm, from eqcircuit.

[id, iq, U] = get_max_torque_eq(this, rpm)

.OPsimulator/get_op is a function.

[solution, id, iq, T0, U0, data] = get_op(this, Ttarget, rpm)

.OPsimulator/get_op_FW is a function.

[solution, id, iq, Tnow, Unow] = get_op_FW(this, Ttarget, rpm, id, iq, Tnow, Unow)

.OPsimulator/get_op_MTPA is a function.

[solution, id, iq, Tnow, Unow] = get_op_MTPA(this, Ttarget, rpm, id, iq, Tnow)

.get_op_eq Iterate rough operating point with equivalent circuit.

.init_current_ripple Initialize current ripple.

init_current_ripple(this, id, iq, rpm) Sets current ripple if not already set.

.init_detailed Initialize for detailed FEA computation.

[T, U, solution] = init_detailed(this, id, iq, rpm)

  • calculate equivalent circuit parameters with DETAILED accuracy settings.

  • set current ripple waveform if needed.

.RESET Reset graphics object properties to their defaults.

RESET(H) resets all properties having factory defaults on the object identified by handle H to their default values. If h is a figure, MATLAB does not reset PaperPosition, PaperUnits, Position, Units or WindowStyle. If h is an axes, MATLAB does not reset Position and Units.

For example, RESET(GCA) resets the properties of the current axis. RESET(GCF) resets the properties of the current figure.

See also CLA, CLF, GCA, GCF, HOLD.

.simulate_op Simulate operating point.

[T, U, solution] = simulate_op(this, id, iq, rpm)

  • Simulates given operating point with the DETAILED precision settings.

  • Updates equivalent circuit parameters.